Hello!
I have reinstall the driver without --basic:
[root@localhost mnt]# ./mlnxofedinstall
Logs dir: /tmp/MLNX_OFED_LINUX-2.2-1.0.1.4850.logs
Preparing... ##################################################
mpitests_mvapich2__2_0rc1 ##################################################
Preparing... ##################################################
mpitests_openmpi__1_6_5 ##################################################
Preparing... ##################################################
mpitests_openmpi__1_8_2 ##################################################
Device (06:00.0):
06:00.0 Ethernet controller: Mellanox Technologies MT26468 [ConnectX EN 10GigE, PCIe 2.0 5GT/s Virtualization+] (rev b0)
Link Width: 8x
PCI Link Speed: 5Gb/s
Device (09:00.0):
09:00.0 Ethernet controller: Mellanox Technologies MT26468 [ConnectX EN 10GigE, PCIe 2.0 5GT/s Virtualization+] (rev b0)
Link Width: 8x
PCI Link Speed: 5Gb/s
Device (09:00.1):
09:00.1 Ethernet controller: Mellanox Technologies MT26468 [ConnectX EN 10GigE, PCIe 2.0 5GT/s Virtualization+] (rev b0)
Link Width: 8x
PCI Link Speed: 5Gb/s
Installation finished successfully.
Attempting to perform Firmware update...
Querying Mellanox devices firmware ...
Device #1:
----------
Device Type: ConnectX2
Part Number:
Description: HP NC542m Dual Port Flex-10 10GbE BL-c Adapter
PSID: HP_0150110010
PCI Device Name: 0000:06:00.0
Versions: Current Available
FW 2.9.1530 N/A
CLP 0 N/A
Status: No matching image found
Device #2:
----------
Device Type: ConnectX2
Part Number:
Description: HP NC542m Dual Port Flex-10 10GbE BL-c Adapter
PSID: HP_0150110010
PCI Device Name: 0000:09:00.0
Versions: Current Available
FW 2.9.1530 N/A
CLP 0 N/A
Status: No matching image found
Log File: /tmp/MLNX_OFED_LINUX-2.2-1.0.1.4850.logs/fw_update.log
Failed to update Firmware.
See /tmp/MLNX_OFED_LINUX-2.2-1.0.1.4850.logs/fw_update.log
To load the new driver, run:
/etc/init.d/openibd restart
WARNING: /etc/infiniband/openib.conf saved as /etc/infiniband/openib.conf.rpmnew
[root@localhost mnt]# /etc/init.d/openibd restart
Unloading HCA driver: [ OK ]
Loading HCA driver and Access Layer: [ OK ]
Setting up InfiniBand network interfaces:
Setting up service network . . . [ done ]
The same issue is still alive!! the same problem...
File-Upload.net - MLNX_OFED_LINUX-2.2-1.0.1.4850.logs.rar
All Ports are up and i can ping from my laptop! But 2 Switches are Power Off! This is not correct...
I say all traffic goes over Cisco Switch 1 on Bay1! This is a Driver and CentOS 6.5 Problem!! Because its works under Windows Server 2008 R2! HP Support have test it and i too!