Clik here to view.
Re: mlnx-en-3.2-1.0.1.1 installation blues
Hello, it seems like you are running a NIC from an older generation of cards. Please refer to the driver release notes and check if your cards is in the supported matrix :...
View ArticleRe: mlnx-en-3.2-1.0.1.1 installation blues
Hi, Just as I suspected, it is not supported. Nevertheless, latest mlnx-en works ;-)Which driver do you recommend for high sustained throughput? OFED or mlnx-en?What does GT/s mean?Where can i find...
View ArticleRe: mlnx-en-3.2-1.0.1.1 installation blues
Hi, Actually, i'm a bit confused. mlxup v 4.0.0 reports my card as ConnectX2: Querying Mellanox devices firmware ... Device #1:---------- Device Type: ConnectX2 Part Number: 666172-001 Description: HP...
View ArticleRe: Mellanox Technologies MT26468 [ConnectX EN 10GigE, PCIe 2.0 5GT/s...
Hi Rage, In Version 6.2 I use the integrated driver which comes with the XenServer Setup - I'm not familiar with the Supplemental Pack and also not a Linux specialist :-(The problem is also, that I'm...
View ArticleRe: How can I change the protocol per HCA On same ESXi 6 host?
Hello Jae-Hoon Choi, There is no problem to change the protocol per HCA.For that, you can install Mellanox firmware tool (MFT) from Mellanox public website and use the mlxconfig tool.For example:...
View ArticleClik here to view.
Re: Windows 2012 RDMA Storage Options
Assuming your adapters are capable of using Infiniband or RoCE - try using samba 4.0 (supports SMB-direct) that shares filesystem between Linux & WindowsIt is an open source implementation of SMB...
View ArticleRe: mlnx-en-3.2-1.0.1.1 installation blues
Hi, My PSID: HP_0F60000010Could this be used to check if my card is ConnectX or ConnectX-2? TIA,Nikos
View ArticleRe: How can I change the protocol per HCA On same ESXi 6 host?
Thank you for your answer.I'm made a VPI Gateway with my 2 of SX6036G FDR Gateway systems on vSphere environment today.Test was successful.This system works like charm with Untangle 12 that running on...
View Articleboot problem SX6512
I have a SX6512 with two management modules and upon booting it appears to boot fine (which I watched through the consoles). The problem is whenever I ssh to it or http to it I get the following...
View ArticleRe: boot problem SX6512
Try to remove one of the mgmt modules. I would start with mgmt module #2
View ArticleClik here to view.
Re: How can I find SX6036G Switch GUID on CLI?
The one node license means that the license is only for one switch. Once the license is installed on the switch it supports up to 648 ports.
View ArticleClik here to view.
Atomics with EDR cards
I want to know if verbs-level atomics (fetch_and_add, compare_and_swap) are supported with the following EDR card? CA 'mlx5_0' CA type: MT4115 Number of ports: 1 Firmware version: 12.14.2036...
View ArticleRe: Ethernet Switch: which MIB to read for learned unicast MAC addresses?
Hi Ophir, Marina, Any news on this? Thanks again,Dan
View ArticleConnectX-2 EN Digital Optical Monitoring
Some SFP+ modules exports diagnostics.On Linux this can be retrieved by the "ethtool -m|--dump-module-eeprom|--module-info" command (see Re: Optics (SFP) monitoring on ixgbe and igbe — Linux Network...
View ArticleHow to configure infiniband connectX-3 on to Kernel based Virtual Machine (KVM)
Hi All, i am trying to configure IB0 virtual interface on KVM. I have enabled SR-IOV on my bios, also VT-d is enabled. installed with MLNX_OFED updated verionsFirmware on CA is also updated with...
View ArticleClik here to view.
Re: MLNX_OFED Update for kernel 3.19 in Ubuntu 14.04.3
Hi, does anyone know how I can contact Mellanox for this issue? Thanks
View ArticleConnectX-2 CQE remote access error (Protection Error on remote data buffer)...
Dell hardware running Oracle Solaris 11.3 serving as a storage appliance: Kernel version: SunOS 5.11 11.3Entire Version : 0.5.11-0.175.3.4.0.5.0System Type: Dell PowerEdge R730xdpci bus 0x0081 cardnum...
View ArticleClik here to view.
Clik here to view.
What is the status of addressing CVE-2016-4565
This CVE is quite important as it affects (afaict) all or nearly all Infiniband stacks (from distribution specific, to OFED, to MOFED). Status is that the public PoC allows writing of arbitrary kernel...
View Article