cannot config port2 of mellanox mhqh29b-xtr in windows server 2003, connect cable,but it show media disconnect.the following is like vstat command output,I config the ip of port2 ,but is it appear port2 of mhqh29b-xtr media disconnect ,what I need to do to let it up,thanks!
Ethernet adapter Local Area Connection 7:
Media State . . . . . . . . . . . : Media
disconnected
Description . . . . . . . . . . . : Mellanox
IPoIB Adapter #4
Physical Address. . . . . . . . . :
00-05-AD-04-E7-C6
Ethernet adapter Local Area Connection 6:
Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : Mellanox
IPoIB Adapter #3
Physical Address. . . . . . . . . :
00-05-AD-04-E7-C5
Dhcp Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
Autoconfiguration IP Address. . . :
169.254.53.191
Subnet Mask . . . . . . . . . . . : 255.255.0.0
Default Gateway . . . . . . . . . :
C:\<my directory>vstat
hca_idx=0
uplink={BUS=PCI_E, SPEED=2.5 Gbps,
vendor_id=0x05ad
vendor_part_id=0x6278
hw_ver=0xa0
fw_ver=0x400080395
node_guid=0005:ad00:0004:e7c4
num_phys_ports=2
port=1
port_state=PORT_ACTIVE (4)
link_speed=2.5 Gbps (1)
link_width=4x (2)
rate=10 Gbps
port_phys_state=LINK_UP (5)
active_speed=2.5 Gbps (1)
sm_lid=0x0001
port_lid=0x0002
port_lmc=0x0
max_mtu=2048 (4)
port=2
port_state=PORT_DOWN (1)
link_speed=NA
link_width=NA
rate=NA
port_phys_state=POLLING (2)
active_speed=2.5 Gbps (1)
sm_lid=0x0000
port_lid=0x0000
port_lmc=0x0
max_mtu=2048 (4)